Manual Tape-Programming (For Audio Cd) - Yamaha CDX-497 Bedienungsanleitung

This is for recording desired tracks in any order onto a tape.
3, 5
4
1
Follow steps 1 – 3 on page 16.
2
Press PROGRAM.
PROGRAM
3
Use numeric buttons to select desired tracks (to be
recorded on the side A) in any order.
* Programmed track numbers light up on the display.
4
When track selection for side A is finished, press
TAPE.
TAPE
A pause is inserted.
18
En

Manual tape-programming (for Audio CD)

1 2 3 4
5 6 7 8
9 0 INDEX
DIMMER RANDOM
REPEAT A–B PROGRAM CLEAR
2
SYNCHRO TAPE PEAK SPACE
SEARCH
Blinks.
1 2 3 4
5 6 7 8
9 0
7, 8
5
Use numeric buttons to select the track numbers (to
be recorded on the side B) in any order.
PROG.
6
Press PROGRAM.
7
Start recording on the tape deck, and then press
8
This unit automatically pauses at the end of the side
A. Turn the tape over to the side B, resume
recording on the tape deck, and then press
playback.
Notes
● If, in step 3 or 5, "Err" appears on the display, the track number
just selected cannot be programmed because there is not
enough time remaining on the tape.
● In step 3 or 5, each time a selection is made, the track number
and the remaining time of the tape is displayed, and then the
display changes to indicate the next program number.
● You can check, cancel or correct program data. (For details,
PROG. refer to page 15.)
* When checking program data, note that "Pu" appears
between track numbers for side A and side B.
● Up to 40 tracks can be programmed. If, however, a pause is
inserted, it is counted as one track.
● CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 7 and 8, press
SYNCHRO and then press
unit. Recording automatically starts. (For details, refer to page
21.)
DIMMER RANDOM
REPEAT A–B PROGRAM CLEAR
SYNCHRO TAPE PEAK SPACE
SEARCH
TIME/INFO
FOLDER
1 2
5 6
9 0
on the remote control of this unit.
on the remote control of this unit to start
on the remote control of this
6
8
3 4
7 8
or