Program Playback - Yamaha CD-S2100 Bedienungsanleitung

Controls and functions

■ Program playback

In the program playback mode, you can play back tracks
in a programmed sequence.
1
Press PROGRAM while playback is stopped.
This unit is set to the program editing mode.
2
Select a track by using the numeric buttons
and press ENTER.
3
Repeat step 2 to program the next track.
You can program up to 24 tracks.
4
Press the p (Play) key.
Playback starts from the beginning of the
programmed sequence.
Notes
• This operation is ineffective for MP3 or WMA discs.
• The programmed tracks are erased in the following cases:
– when the disc is ejected
– when this unit is turned off or goes to STANDBY mode
– when an audio source other than the disc is selected
– when the playback layer of a hybrid Super Audio CD is
switched between SA-CD and CD
14
En
■ Setting the AUTO POWER STANDBY
function
The AUTO POWER STANDBY function can be set to
ON or OFF. When set to ON, if the unit is not operated for
30 minutes with no audio signal detected, it automatically
goes to STANDBY mode. When set to OFF, the unit does
not go to STANDBY mode automatically.
1
Open the disc tray and remove any currently-
loaded disc from the unit.
Skip step 1 to 3 if "NO DISC" appears on the
information display.
2
Close the disc tray.
3
Press SOURCE to select "DISC" as the audio
source.
"NO DISC" appears on the information display.
4
Press and hold the
key on the front panel for about 2 seconds to
switch the setting.
(Stop) key: The AUTO POWER STANDBY
function switches to ON, and
"AutoSTBY ON" appears on the
information display.
(Play) key: The AUTO POWER STANDBY
function switches to OFF, and
"AutoSTBY OFF" appears on the
information display.
Notes
• The default setting for the AUTO POWER STANDBY function
is ON.
• This setting is retained even if you turn off this unit.
(Stop) key or (Play)