Settings In Automatic Mode - Multiplex B6 EQ-BID Bedienungsanleitung

6.2

SETTINGS IN AUTOMATIC MODE

The battery charger automatically sets the charging/discharging current and the number of
cells in automatic mode. This mode is only available for NC and NiMH battery packs. The
types of battery are selected with the MODE button.
With the battery connected, the required operation is initiated by pressing the START but-
ton. Accompanied by an acoustic signal, the display changes over to the working display
(see Section 5.2, Page 8).
The process can be terminated by pressing the STOP button; the display for automatic
mode is then shown again.
Operating Instructions
Power Peak ® B6 EQ-BID
The achieved values are shown in the display at the
end of the process when the battery is fully charged
or discharged.
11 43
# 30 8561