Napoleon BIPRO 500 Bedienungsanleitung Seite 16

16
Problem
Ignitor, oven and
EN
cabinet lights work
but the knob lights
don't illuminate when
turning the power
switch ON
Illumination of the
knob and switch
lights work fine, but
the side/rear burner
ignition does not
work
Illumination but can't
ignite the side or rear
burner, even when
sparking noise occurs
www.napoleon.com
N415-0541CE-GB-DE.indd 16
Possible Causes
The motion sensor detector does
not work properly
The wire harness does not work
properly
The ignitor switch does not work
properly
The ignitor block does not work
properly
The gap between electrodes is too
big or too small
Solution
Ensure the blue indicator is ON
Turn the sensor ON by clicking the motion
detector button
If blue indicator is ON, replace the motion
sensor
Replace the wire harness of the control
panel
Replace the ignitor switch if the switch
light illuminates when you turn the light
switch on
Check the switch connection inside the
control panel If there's no light on the
switch when you turn it on.
Replace the ignitor block if the switch
illuminates and sparking noise can be
heard.
Adjust the gap between two prongs of
the side burner electrode when the side
burner does not ignite.
Adjust the gap between the electrode
and the rear burner when the rear burner
when the rear burner foes not ignite
N415-0541CE-GB-DE JuNE 04.19
6/4/2019 10:29:22 AM