Napoleon BIPRO 500 Bedienungsanleitung Seite 15

N415-0541CE-GB-DE JuNE 04.19
N415-0541CE-GB-DE.indd 15
Problem Possible Causes
Burner output on Lack of gas.
"high" setting is
too low. (Rumbling Supply hose is pinched.
noise and fluttering
blue flame at burner Dirty or clogged orifice.
surface.)
Spider webs or other matter in
venturi tube.
Infrared burner (if Ceramic tiles overloaded with
equipped) flashes grease drippings and build-up.
back (during Ports are clogged.
operation the burner
abruptly makes
a loud "whoosh"
sound, followed by Burner overheated due to
a continuous blow- inadequate ventilation (too much
torch type sound and grill surface covered by griddle or
grows dim.) pan.)
Cracked ceramic tile.
Leaking gasket surrounding the
ceramic tile, or a weld failure in
the burner housing.
Pilot will not light. Lack of gas.
(if equipped)
Obstruction in pilot orifice.
Electrode wire loose or off.
Dirty pilot electrode.
Pilot is actually lit.
Illumination and Side/ Electric Power is out
Rear burner ignition
The grill is nor receiving electric
k
do not wor
power
Solution
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
Turn burner off and allow to cool for at
least two minutes. Relight burner and
burn on high for at least five minutes or
until the ceramic tiles are evenly glowing
red.
Ensure that no more than 75% of the
grill surface is covered by objects or
accessories. Turn burner off and allow to
cool for at least two minutes, then relight.
Allow burner to cool and inspect very
closely for cracks. If any cracks are found,
contact your authorized Napoleon dealer
to order a replacement burner assembly.
Contact your authorized Napoleon dealer
for instructions on ordering a replacement
burner assembly.
After turning pilot knob to high, wait
approximately 20-30 seconds for air to
purge the gas supply line while pressing
igniter. Fill propane cylinder. During initial
set-up or after tank has been refilled, it is
best to light one of the tube burners before
lighting the pilot burner. This enables the
gas to reach the valves on the manifold
more quickly.
Clean pilot orifice.
Replace lead wire.
Clean pilot electrode.
The pilot flame, especially on natural gas
units is very difficult to see. Place your
hand 1 in. (2.5 cm) above grill surface over
the pilot burner to feel for heat.
Check the power outage in your area
Ensure the grill is connected between the
wall and the power bar of the grill
Ensure the red indicator is ON in the
control box
Check if the fuse on the wire in the cabinet
is broken or not
www.napoleon.com
15
EN
6/4/2019 10:29:22 AM