DT SWISS F 232 ONE Bedienungsanleitung Seite 24

4. SETUP
In addition to the information shown here, you will find useful tips and videos on adjusting the fork at
www.setupguide.dtswiss.com
4.1 ADJUSTING THE AIR PRESSURE
Rider weight
(rider with equipment, without bike)
[kg]
40
45
50
55
60
65
70
75
80
85
90
95
100
105
110
INCREASING THE AIR PRESSURE
1. Set the fork to "OPEN" mode (see "4.2 Setting the riding
mode" on page 26).
2. Unscrew the valve cap.
3. Screw on the shock pump and inflate the fork up to the
required pressure.
→ Follow the instructions issued by the pump
manufacturer!
4. With the shock pump attached, slowly compress the fork
twice by about 10 mm and then decompress fully.
→ This equalizes the positive and negative air chambers.
→ Once the pressure displayed on the shock pump stops changing after compression, the two air
chambers have equalized.
5. Repeat steps 4 and 5 until the desired pressure is displayed on the shock pump after compression.
6. Unscrew the shock pump and screw the valve cap onto the valve.
24
[lbs]
88
99
110
121
132
143
154
165
176
187
198
210
220
232
245
max. air pressure:
100 mm 110 mm
[bar] [psi] [bar]
2.8 41 2.7
3.3 47 3.1
3.7 54 3.5
4.1 60 3.9
4.5 66 4.3
5.0 72 4.7
5.4 78 5.1
5.8 84 5.6
6.2 90 6.0
6.7 97 6.4
7.1 103 6.8
7.5 109 7.2
7.9 115 7.6
8.4 121 8.0
8.8 127 8.4
10,5 152 10,3
Travel
120 mm
[psi] [bar]
39 2.5
45 2.9
51 3.3
57 3.7
63 4.1
69 4.5
75 4.9
81 5.3
87 5.7
93 6.1
98 6.5
104 6.9
110 7.3
116 7.7
122 8.1
149 10
[psi]
37
42
48
54
60
66
71
77
83
89
94
100
106
112
118
145