Power On/Off - geo-FENNEL FL 220HV Bedienungsanleitung

EN
HORIZONTAL USE
After powering on the unit a flashing laser diode indicates that the automatic self-levelling procedure is
working. The laser starts rotating when it is self-levelled. If not the laser was set up outside of its self-
levelling range. In this case set up the instrument on a more even surface.
6

POWER ON/OFF (1)

Power the laser on/off with button (1). If the red ON/OFF LED (2) is illuminated the laser is powered on.
First the laser dot is flashing, then the self-levelling procedure starts automatically; meanwhile the TILT
LED (5) is flashing. When the self-levelling procedure is completed the laser rotates with 600 rpm and
the TILT LED (5) is illuminated permanently (= TILT function activated).
If in normal use the ON/OFF LED (1) flashes the battery has to be recharged.
TILT MODE (6)
After completion of the self-levelling procedure the TILT mode is automatically enabled.
If the level is now disturbed the rotation stops and the TILT LED is flashing.
1. Press the TILT button (6) once: The rotation of the laser starts - but the TILT mode is disabled.
2. Press the TILT button (6) twice: The rotation of the laser starts, the self-levelling procedure is
completed and the laser restarts working with enabled TILT mode.
Press button (6) to disable the TILT mode after completion of the self-levelling procedure.
16
3
5
4
1. ON/OFF button
2. ON/OFF LED
3. MANUAL button
4. MANUAL LED
5. TILT LED
1
6. TILT button
2