Before Use; Set-Up - Silvercrest SLR 55 A1 Bedienungs- Und Sicherheitshinweise

Safety instructions / Before use / Set-up
Do not pull on the mains con-
nection cable to move or shift
the product.
Do not move the product during
use.
Do not carry out any modifica-
tions or repairs to the device
yourself.
DANGER OF ELECTRIC
SHOCK! If damaged, the mains
connection cable must be re-
placed by the manufacturer or
its authorized service centre to
avoid any hazards. Otherwise
there is a risk of electric shock.
Do not use extension cords.
Do not block the air inlet and air
outlet grilles.
Place the product on an even,
level surface.
Keep the product and cable away
from heat, oil and sharp edges.
Do not operate the product in
potentially explosive environments
with inflammable vapours, gases
or dusts.
Protect the product from direct
sunlight.
Keep the product away from ra-
diators and other sources of heat.
Do not stand or sit on the product.
If the product has not been used
for a prolonged period and you
32 GB/MT
notice a burnt smell when starting
the device or the mains connec-
tion cable and plug become hot,
switch off the device, unplug from
the mains socket and contact a
specialty retailer.

Before use

Note: Remove all packaging material from the
product.
P lace the product on a stable, even surface at
least one meter away from a wall. The air inlet
and air outlet ,
8
blocked.
Remove the front cover
Remove the HEPA / activated carbon pre-filter
and the activated carbon filter
6
product (see Fig. CII and CIII) and remove the
plastic packaging.
Now, replace the activated carbon filter
then the HEPA / activated carbon pre-filter
the product. The black side of the HEPA / acti-
vated carbon pre-filter
Now attach the front cover
CIV).
Now insert the mains plug
socket. The product will sound a beep and all
LEDs will light up briefly.

Set-up

P ress the ON / OFF button
start in the first level of auto mode.
S elect the fan speed (1 / 2 / 3) by pressing the
option key . The LED assigned to the function
14
will light up.
Note: A beep will sound when the buttons are
pressed.
must not be covered or
3
(see Fig. CI).
5
from the
7
7
6
must be facing forward.
6
again (see Fig.
5
into the mains
4
. The product will
12
and
in