Installation Accessories - Kenwood KDC-5057SD Kurzanleitung

For Good Reception
To assure good reception, note the
following:
• Communicate with the cell phone within
the line-of-sight distance of 10 m (30
ft). The communication range becomes
shorter depending on the surrounding
environment. The communication
range also becomes shorter when there
is an obstacle between this unit and
the cell phone. The above maximum
communication range (10 m) is not
always assured.
• A broadcast station or walkie-talkie
located nearby can interfere with
communication due to a too strong
signal.

Installation accessories

1
.....1
2
.....2
3 [1][2]
.....1 (3m)
4 [1]
.....1
5 [1]
.....1
6 [1]
.....3
7 [1]
.....1
[1] K DC-BT73DAB only
K DC-BT53U only
[2]
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive.
Make sure to make the proper connections
to prevent damage to the unit.
The default connection for the wiring
harness is described in 1 below. If the ISO
connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as
shown 2 below to install this unit to the
Volkswagen vehicles etc.
1 When the A-7 pin (red) is connected with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply
of the vehicle's ISO connector (default):
Ignition cable
(Red)
Unit
Battery cable
(Yellow)
2 When the A-7 pin (red) is connected
to the constant power supply, and the
A-4 pin (yellow) is connected with the
ignition of the vehicle's ISO connector:
Ignition cable
(Red)
Unit
Battery cable
(Yellow)
A-7 Pin
(Red)
Vehicle
A-4 Pin
(Yellow)
A-7 Pin
(Red)
Vehicle
A-4 Pin
(Yellow)
English | 11