Using The Security Lock - JVC KD-LX110 Bedienungsanleitung

Using the security lock

You can prohibit the unauthorized use of this unit
by the others.
To use the security lock, you need to set the
password first. Once you set the password, the
unit will ask you to enter the password when you
turn on the unit for the first time after re-installation
(or after recovering the car battery exhaustion).
CAUTION: Be careful not to forget the password
you have entered; otherwise, you cannot use
this unit. Keep the password in your mind and
more importantly on paper or some other
materials. You can write down your password
in the spaces provided on the cover page.
Registering the password
You have to use 4 characters for your password.
You can use the following characters: Capital letters
(A – Z) and numerals (0 – 9).
1
Press and hold both buttons for more
than 2 seconds.
The unit enters password entry mode.
2
Select a character.
As you turn the control dial,
character changes as
follows:
A
9.......
3
Move the character entry position to
the next.
4
Repeat steps 2 and 3 until you enter
all 4 characters.
5
Press SEL (select) to finish the setting.
The password flashes on the
display for a while, then the
unit returns to the normal
operation mode.
How to Use the Provided CODE Sticker
Attach the provided CODE sticker in a
conspicuous position on your car to notify
would-be unauthorized users that the security
lock function is provided for this unit and,
therefore, will foil their efforts.
B C..............Z
(alphabets)
2 1 0
(numerals)
27