Installation - Makita AF550H Bedienungsanleitung

Service
Perform cleaning and maintenance right after
•
finishing the job. Keep the tool in tip-top condition.
Lubricate moving parts to prevent rusting and
minimize friction-related wear. Wipe off all dust
from the parts.
Ask Makita authorized service center for periodical
•
inspection of the tool.
To maintain product SAFETY and RELIABILITY,
•
maintenance and repairs should be performed by
Makita Authorized Service Centers, always using
Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.

INSTALLATION

Selecting compressor
L/min
Nailing frequency (times/min.)
009270
Select a compressor that has ample pressure and
•
air output to assure cost-efficient operation. The
graph shows
frequency, applicable pressure and compressor air
output. Thus, for example, if nailing takes place at
a rate of approximately 60 times per minute at a
compression of
compressor with an air output over 45 L/min is
required. Pressure regulators must be used to limit
air pressure to the rated pressure of the tool where
air supply pressure exceeds the tool's rated
pressure. Failure to do so may result in serious
injury to tool operator or persons in the vicinity.
the relation between
1.76 MPa (17.6
Selecting air hose
WARNING:
Use a high pressure resistant air hose. The air
•
pressure used for this nailer is higher than that for
other general finishing nailers.
Fig.1
Use an air hose as large and as short as possible
•
to assure continuous, efficient nailing operation.
CAUTION:
Low air output of the compressor, or a long or
•
smaller diameter air hose in relation to the nailing
frequency may cause a decrease in the driving
capability of the tool.
Lubrication
Before and after use, oil the tool with pneumatic tool oil
by placing two or three drops into the air fitting. For
proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
Fig.2
nailing
bar), a
7