Recommended Fuels - ADURO H1 Bedienungsanleitung

IMPORTANT
If the door to the combustion chamber is open for more than 3 minutes, the pellet combustion will shut
down and must be started again by pushing ON/OFF. The stove starts when the smoke temperature is
below 100 degrees C. If the stove blinks green ON, it means that the stove will start, but is waiting for the
smoke temperature to be below 100 degrees C or timer.
When you want to switch off the pellet burner, push the ON/OFF button. If you open the stove door during
operation, the red ALARM lamp will be on. If you close the door before 3 minutes, the pellet burner goes
back to ON mode automatically.
3.4 How should I use my Aduro H1?
The Aduro H1 is intended for intermittent combustion. This means that each stoking should burn down to
embers before new logs are added.
In order to obtain the best possible combustion, you should regulate the effect/heat output with the fuel.
Burning small logs provides more powerful combustion than burning large logs as the surface area is greater
and more gas is released. The amount of wood in the combustion chamber is another factor that affects
combustion. In normal circumstances, you should not place more than two logs in the stove. If you want an
enhanced effect, you can add more logs. The nominal heat output is reached by burning approx. 1.5 kg per
hour, divided between 3 pieces with a length of approx. 21 cm.
The pellet function can burn up to 24 hours on a full pellet container at level 1, level 2 for 12 hours and level
3 for 8 hours. The stove is capable of running day and night, if pellets are added in time.

3.5 Recommended fuels

3.5.1 Wood and wood briquettes
Wood that has been stored indoors has a tendency to become too dry and will burn too quickly. The wood
should preferably be felled in the winter, when a lot of the moisture in the wood will have been drawn down
into the roots. In order to achieve optimum combustion, the wood's moisture level should not exceed 18 %,
which roughly corresponds to storing the wood under cover outdoors for one year. The moisture level of the
wood can be measured using a moisture meter or by applying washing up liquid to one end of the log and
blowing air in the other end. If the wood is dry enough, soap bubbles will appear. The wood should be
chopped into logs with a diameter of approx. 10 cm and a log length of max. 39 cm.
Correct firing provides optimal heat output and maximum economy. At the same time, correct firing prevents
environmental damage in the form of smoke and malodorous fumes and also reduces the risk of chimney
fires. Well-seasoned wood fuel is essential for correct use. Make sure your fuel is kept dry. If the fuel is wet,
a large proportion of the heat will be used to vaporize the water, and this energy will disappear up the
chimney. It is clearly not only uneconomical to fire with wet fuel but also, as mentioned above, increases the
risk of producing soot, smoke and other environmentally damaging by-products.
Burning varnished wood, impregnated wood, chipboard, paper and other waste is strictly forbidden. Burning
these materials will damage the environment, the Aduro H1 and your own health. Fossil fuels must not be
used.
59