ADURO H1 Bedienungsanleitung Seite 56

When stoking
Each time fresh wood is put in the stove, a precise amount of primary air will be allowed in for the first few
minutes. What's more important is that the primary air is not allowed in for too long. This is to ensure
optimum combustion. The Aduro-tronic control will ensure intake of primary air at the right tempo. The
automatic is activated by pulling the primary damper out each time fresh wood is put in the stove. The
automatic closes then the primary air gradually.
Regulation of the Aduro-tronic control
The control is pre-set to allow primary air intake for the first 5 minutes. This setting has been used during
testing at the Danish Technological Institute using 'standard' sized logs and with maximum moisture content
of 18%. Standard size logs are approx. 30 cm long and 10 x 10 cm in thickness. A standard chimney was
also used for testing. In practice, such circumstances can differ, which is why the Aduro-tronic control can be
adjusted to your circumstances. If you want a slower intake of primary air: (e.g. for a slower flue draught,
larger sized wood or for longer intervals between stoking) Adjust the screw on the front of the control level
using a small allen key to slow closure rate. If the screw is turned to the right closing time is increased and if
turned to the left closing time is reduced. The Aduro-tronic must be closed within 6 minutes.
3.3 How do I light the fire in my Aduro H1?
You can light the fire using just pellets or light it manually with wood – or a combination where you put
firewood in the combustion chamber and use the pellets to light the fire.
Aduro H1 has a damper (see illustration below) where you manually can switch off the air supply to the pellet
combustion. When this damper is closed, the pellet function won't work. This damper is mounted since you
have to shut off air supply to the pellet function in order to obtain the most optimal combustion of wood
pieces. If you use an Aduro H1 with wood and pellets, the damper has to be open (pulled forwards).
NOTE: The first time you light the fire in the hybrid stove, you should use normal firewood because the door
has to stand slightly ajar. This should be done to prevent the gasket from sticking to the paint on the stove.
56