Sanus VuePoint F18b Montageanleitung Seite 8

2 Mount the Wall Plate
2-1
Locate studs
< 16 mm
(5/8 in.)
2-2
Mark the wall
[02]
2-3
Drill pilot holes
2-4
Tighten lag bolts
[16]
8
[02]
Verify the center of the stud(s) using an awl, a thin nail, or an edge
to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!

Any material covering the wall must not exceed 16 mm
(5/8 in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.
(nominal 38 x 89 mm (1½ x 3½ in.))
Level the wall plate [02] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 63.5 mm (2½ in.), using a
3 mm (1/8 in.) diameter drill bit.
63.5 mm
2.5 in.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt.
To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolts [16].
11mm 3 mm
)
(7/16 in.) (1/8 in.
6902-002028 <00>