Technical Data; Closing The Door; Installation - AEG S83200CMB0 Benutzerinformation

46

Technical data

Problem
"dEMo" appears on the
display.
As much as the advice does not lead to result, call the nearest brand-mark service.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
Install this appliance at a location where the ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the appliance:
Possible cause
The appliance is in demonstra-
tion mode.
Height
Width
Depth
Solution
Keep pressed approximately 10
sec the OK button since a long
sound of buzzer is heard and the
display shut off for a short while:
appliance start works regularly.
1850 mm
595 mm
658 mm
18 h
230 - 240 V
50 Hz