Specifications; Standard Equipment; Electromagnetic Compatibility (Emc) - RIDGID RE 6 Bedienungsanleitung

QCS Type
Label
QCS Sleeve
LED
Pressure
Work
Release
Light
Run
Button
Switch
Warning Labels
Figure 1 – RE 6 Electrical Tool
Figure 2 – LED Diagnostic Display

Specifications

RE 6 and RE 60 Electrical Tools:
RE 6
Piston Force ...............11,900 lbf
6-ton (short)
(53kN)
Piston Travel ..............1.26"
(32mm)
QCS Type ..................6T QCS
Duty Cycle..................
Motor
Voltage ...................18V DC
Amperage ...............18 Amp
Power .....................324 Watts
Battery........................18V Li-Ion, Rechargeable
Battery
Operating Temperature
Range ...........................15° F to 122° F (-10° C to 50° C)
Sound Level ................92 dBa
Vibration ......................59 in/s
Weight (with Battery)...5 lb (2.27 kg)
Fabric Loop
Battery
LED
ON/OFF
Button
RE 60
60kN
6-ton
(13,500 lbf)
24mm
(0.94")
60kN QCS
3 Cycles per minute
2 (1.5 m/s 2 )
RE 6/RE 60 Electrical Tool
Electric Tool serial number plate is located on the rear of
the tool (Figure 3) . The first 4 digits indicate the year
and month of the manufacture. (12 = year, 06 = month).
ON/OFF
Button
Figure 3 – Machine Serial Number

Standard Equipment

The Electrical Tool, if ordered with batteries, comes with
2.0Ah batteries. 4.0Ah batteries are available as acces-
sories (See Accessories) . Higher amp hour batteries
allow more tool cycles per charge, but also weigh more.
The RIDGID ® Model RE 6/RE 60 Electrical Tool comes
with the following:
• RIDGID ® Model RE 6/RE 60 Electrical Tool
• Operator's Manual
NOTICE Selection of appropriate materials and joining
methods is the responsibility of the system designer
and/or installer. Before any installation is attempted, care-
ful evaluation of the specific service environment, includ-
ing chemical environment and service temperature, should
be completed. Consult connector manufacturer for selec-
tion information.
Electromagnetic Compatibility
(EMC)
The term electromagnetic compatibility is taken to mean
the capability of the product to function smoothly in an
environment where electromagnetic radiation and elec-
trostatic discharges are present and without causing elec-
tromagnet interference to other equipment.
The RIDGID Model RE 6 and RE 60 Electri -
®
NOTICE
cal Tools conform to all applicable EMC standards.
However, the possibility of it causing interference in other
devices cannot be precluded.
5