Toshiba e-studio230 Bedienungsanleitung Seite 176

JUSTAGEMODUS 08 <e-STUDIO232-283>
Code Justage
Response to PJL job
3797
commands
List Analysis Logic of Scan
3804
to File (FTP)
Department Management
3805
setting by Remote Scan
Direct SMTP
3810
communication setting
Image encrypting at the
3811 Direct SMTP
communication
Dummy full mode at the
3812
Internet Fax transmission
-
TOSHIBA TEC Germany IMAGING SYSTEMS GmbH (Trainingscenter Wolfgang Schwarz)
Der Inhalt dieses Manuals ist ohne Gewähr, und vorbehaltlich jeder Änderung
Justage-
Modus RAM Kommentar
bereich
1
ALL SYS
<0-1>
0
ALL SYS
<0-1>
3
ALL SYS
<0-3>
0
ALL SYS
<0-1>
0
ALL SYS
<0-1>
0
ALL SYS
<0-1>
Seite -170-
During bidirectional communication,
the next job will not be accepted until
the printing of the sent data (all pages)
is finished. If the next job must be
accepted during bidirectional
communication, set the value at
"0: (Solicited)".
0 = (Solicited) – Immediately responds
to the host side after the completion of
RIP.
1 = (Unsolicited) - Responds to the
host side after the printing is finished
Acquisition of Contents in Host side is
switched by Scan to File (FTP).
0 = NLST 1 = LIST
Department Management is set when
Remote Scan is performed.
0 = w/o GUI OFF, w/ GUI OFF
1 = w/o GUI ON, w/ GUI OFF
2 = w/o GUI OFF, w/ GUI ON
3 = w/o GUI ON, w/ GUI ON
When an Internet Fax is sent, Direct
SMTP communication is set.
0 = Disabled
1 = Enabled
When "0 = Disabled" is set, an Internet
Fax is sent using an SMTP server.
When "1 = Enabled" is set, direct
SMTP communication is enabled and
an Internet Fax is sent to MFPs on the
intranet without using an SMTP server.
Since no SMTP server is used, the SSL
encryption and SMTP-AUTH function
cannot be used for internet Fax
transmission.
If "1 = Enabled" is set in 08-3810, set
"1 = Enabled" in 08-3812 as well.
When Direct SMTP communication is
performed, an attached image is
encrypted.
0 = Disabled 1 = Enabled
When an Internet Fax is sent, the
resolution ratio and the paper size of
an
attached image are set to the full
mode.
0 = Disabled 1 = Enabled
If "1 = Enabled" is set in 08-3810, set
"1 = Enabled" in 08-3812 as well.
01.04.2009