Connecting Headphones - Silvercrest SBKN 4.0 B1 Bedienungs- Und Sicherheitshinweise

SilverCrest SBKN 4.0 B1
also vibrates briefly. The LED (4) flashes orange and thus indicates standby
mode. If the headphones were switched on for the first time and had never
been connected to a device, pairing mode is started automatically. The LED (4)
alternates between flashing blue and orange in pairing mode. Read the next
section when connecting your device.
Press the multifunction button (3) for at least 3 seconds to switch off the
headphones. You hear a descending tone sequence in the headphones. The
device also vibrates briefly.

Connecting headphones

Proceed as follows to connect the headphones to your device:
 Switch off the headphones.
 To start pairing mode, press the multifunction button (3) for at least 6
seconds until the LED (4) alternates between flashing blue and orange.
 The headphones are now in search mode. In search mode, you can connect
a compatible device to the headphones via the Bluetooth
 Then connect your smartphone or audio / media player to the headphones
®
via Bluetooth
smartphone or media player. Select the device "SBKN 4.0 B1" from the list
of devices which are found and establish the connection. If you are asked for
a PIN, enter "0000".
After the connection has been established, the process is confirmed with a
vibration and an acknowledgement tone. The LED (4) also flashes blue once
briefly about every 10 seconds. As soon as the device is switched off or is out
of range, the headphones switch to standby mode (not connected) and the LED
(4) flashes orange twice briefly every 3 seconds.
If you want to connect another device (smartphone or media player) to the
headphones, you must repeat the pairing process as described previously.
As soon as the previously connected device comes within range of the
headphones, the connection is established automatically. You may need to
confirm the connection on your device.
14 - English
. For further details, please read the instructions of your
®
function.