Battery Changing - cecotec Conga Ergo Extreme Bedienungsanleitung

BATTERY CHARGING
• WARNING: use only the charger supplied with the appliance. All repairs or battery replacements
must be performed by an authorised technical support service. It is important to charge the
batteries completely before using the appliance for the first time. The first charge will take
approximately 3 hours.
• Attach the charging support piece to the charging support base.
• Hang the appliance on the hook of the charging base. Make sure that the appliance sits properly
on the base.
• Plug the charger to the charging base. Then, plug the adapter to the mains supply.
• Charge the batteries at room temperature between 4 and 40 ºC.
• The pilot light will blink while charging to indicate that the charger is working. When the appliance
is fully charged, the charger will switch off automatically and the pilot light will stop blinking and
remain on.
• After charging, unplug the charger from the mains supply and the charging base. Do not use the
appliance while connected to the charger. Store the charger in a safe place for future charges.
• The appliance is now ready for use.
NOTE:
• Do not store or charge the appliance near heat sources, nor expose it to direct sunlight.
• Do not charge the appliance in dirty or wet places.
ENGLISH
Conga Ergo Extreme 29,6 V
15