Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
Re-adjustement of end limits
8.1 - Re-adjustement of UP end limit:
1- Position the motor on the UP end limit previously set in §3.2 with the UP key.
2- Press simultaneously for 5 seconds the UP and DOWN keys, the motor will run for 0.5 second in one direction and then
in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for 0.5 second in one direction and
then in the other direction. The new end limits setting is memorized.
8.2 - Re-adjustement of DOWN end limit:
1- Position the motor on the DOWN end limit previously set in §3.2 with the DOWN key.
2- Press simultaneously for 5 secondes the UP and DOWN keys, the motor will run for 0.5 second in one direction and
then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Validate the new position by pressing 2 seconds the STOP key. The motor will run for 0.5 second in one direction and
then in the other direction. The new end limits setting is memorized.
9
Cancelling programming
9.1 - Switch off the 12V power supply to the motor for 2 seconds.
- Switch on the 12V power supply to the motor for 7 seconds.
- Switch off the 12V power supply to the motor for 2 seconds.
- Switch the power to the motor back on.
The motor will run for 5 seconds in random direction and is now in the cancelling mode.
9.2- Then, validate the cancelling of the affected motor from the individual control or from a new transmitter
- Press the "PROG" key of the transmitter more than 7 seconds. Maintain
the pressure until the motor will first run for 0,5 second in one direction
and then the other, and a few second later, it will run again in both
direction.
The motor is now as it was originally configured, and no transmitter
and no settings is saved in its memory and is ready for a new programming
(§3).
1
2
5s
1
2
5s
3
2s
3
4
2s
4
4/4
Werbung
