Operation - HANSGROHE AXOR Citterio 39020 series Montageanleitung

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
Hot water temperature:
Recommended hot water temp.: 65° C
Test certificate:

Operation

open
6
English
with
7 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
WRAS
close
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(5a) located behind the aerator must be removed.
Spare parts (see page 3)
1 handle
2 face plate
3 nut
4 cartridge cpl.
5 aerator cpl.
6 fixing set
7 connection hose 900 mm
8 pull rod
9 extension hose 300 mm
Special accessories
X special tool set
(order as an extra)
XXX = Colors
000 chrome plated
420 platinum
hot
®
39091XXX
97466XXX
97157000
96339000
13085XXX
13961000
96316000
96923XXX
13098000
58085000
cold