System Function; Self-Diagnosis; Battery Charging - Pieps Jetforce Bt Bedienungsanleitung

For use during activities that may expose the user to risk of snow avalanche. Avalanches are deadly. Understand
and accept the risks involved before participating in activities that may expose you to avalanche danger. You are
responsible for your own actions and assume the risks of your decisions. This pack may increase your chances for
survival, but it does not guarantee safety in the event of an avalanche. This pack should be used along with other
avalanche safety gear including an avalanche beacon, shovel and probe. Avalanche education is essential before
heading into avalanche terrain. Learn how to avoid avalanches and what to do in case you are caught by one. In
addition to deploying your airbag, swim and fight to stay on top, and attempt to create an air pocket as the slide
begins to slow. Before using this product, read and understand all instructions and warnings that accompany it,
familiarize yourself with its capabilities and limitations and obtain proper training in the use of the equipment.
Practice periodically. Contact Pieps if you are uncertain about how to use this product. Do not modify this product in
any way. Avalanche control workers using explosives are advised that this pack contains electronic equipment which
has not been tested for all conditions and which may expose the user to risks that are not yet known. Be aware of the
potential risks of using electronic equipment including, but not limited to, risks related to overheating, flammability,
explosion, electrical interference and static electricity. Check the manufacturer's website for updated instructions
and firmware. Failure to read and follow the warnings and instructions can result in severe injury or death!
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made
by children without supervision.
WARNING! Only charge the battery using the provided JetForce BT Airbag charger (type:
GlobTek, Inc. GTM91120-3024-T2).
JetForce BT Backpack
INSTRUCTIONS FOR USE
JETFORCE BT BACKPACK INTRODUCTION
The JetForce BT Backpack is designed for use in and around areas with the chance
of snow avalanches. This backpack incorporates the JetForce Avalanche Airbag
System, which is designed to improve the chances of surviving an avalanche. By
increasing the total volume of the person caught in the slide the airbag helps keep
the victim on the surface, decreasing the chances of a complete burial and allowing
for a faster rescue.
JETFORCE BT SYSTEM COMPONENTS
See also: Figure 1
1a: Main Cargo Compartment
1b: Deployment Handle Pocket
1c: Deployment Handle
1d: Power Button
1e: System Status Lights
1f: Charge Status Lights
1g: Lithium-Ion Battery
1h: Charging Plug
1i: Airbag Pocket
1j: Airbag Release Post
1k: Release Clip
1l: Release Flap
1m: Electronics Access Flap
1n: JetForce BT Backpack Instructions
1o: Charging Power Supply
3a: Left Side Buckle

SYSTEM FUNCTION

When the airbag is deployed by pulling the Deployment Handle (1c), the Release Clip
(1k) is forced open, allowing the Release Flap (1l) to open, and then the inflating air-
bag opens the airbag zipper. The airbag can then fully inflate (Figure 2).

SELF-DIAGNOSIS

To ensure that your JetForce BT Avalanche Airbag will function properly, the
JetForce BT electronic system performs a comprehensive self-diagnosis on every
system startup. The system checks the battery charge level, motor and fan opera-
tion and all critical electronics such as status lights,
trigger electronics and the battery electronics. The system also performs frequent
diagnosis while armed. A properly working system indicates a pulsing green System
Status Light (1e), located on the Deployment Handle (1c). Warnings/malfunctions are
indicated with a red System Status Light (1e), in conjunction with the blue Charge
Status Lights (1f). Refer to Troubleshooting section of this manual for details.
4
3b: Right Side Buckle
3c: Leg Strap
3d: Leg Strap Storage Pocket
3e: Leg Strap Clip
3f: Leg Strap Loop
3g: Sternum Strap
5a: Fan Housing
5b: Air Release Button
5c: Deflate Access Port
5d: Airbag Pocket Zipper Pull
5e: Zipper Warning Label
8a: Zip-On Booster Pack
8b: JetForce BT Base Unit
8c: Booster Pack Zipper Pulls
8d: Booster Pack Zipper Ends
WARNING

BATTERY CHARGING

Always make sure the system has a full charge before heading out into avalanche
terrain.
A
WARNING! The airbag may deploy if the Deployment Handle is pulled
anytime the lights are illuminated, even during charging.
1. Locate the Charging Power Supply (1o) and install the correct international plug.
2. Locate the charging connector inside the Deployment Handle Pocket (1b).
3. Unzip and expose the Charging Plug (1h).
4. Plug the Charging Power Supply (1o) cable into the Charging Plug (1h).
5. Plug the Charging Power Supply (1o) into an electrical outlet.
6. The Deployment Handle (1c) will illuminate a solid green light within the System
Status Lights (1e). The charge level is shown by the solid blue Charge Status Lights
(1f) with one blue light blinking to indicate charging state.
7. Charge until the Deployment Handle (1c) shows full charge with 4 solid blue lights.
a. First time charging can be as long as 12 hours.
b. Typical charging time is less than 6 hours.
8. Charge the Lithium-Ion Battery (1g) at room temperature. Do not charge at
temperatures outside of range (0°C to 45°C / 32°F to 113°F). At these extremes,
the system will indicate a charge temperature warning (refer to Troubleshooting
section of this manual) until the battery temperature is inside charge range again
– then charging starts automatically. It can take up to one hour until the battery
temperature reaches the required level.
9. Discontinue charging and refer to the Troubleshooting section of this manual
when you see a solid red System Status Light (1e).
CHECKING THE BATTERY STATUS AND WHEN TO RECHARGE
1. Tap the red Power Button (1d) briefly at any time to illuminate the Charge Status
Lights (1f and Figure 6).
a. 4 blue lights: full charge (maximum number of deployments available).
b. 3 or 2 blue lights: partial charge (multiple deployments available).
c. 1 blue light: at least 1 deployment remaining at -30°C (-22°F).
A
WARNING! After checking the battery status, wait until the Charge Status
Lights (1f) have turned off before arming the system.
2. A blinking red System Status Light (1d) with a single blinking blue light indicates
the battery is not sufficiently charged for a deployment. Do not enter avalanche
terrain.
3. Check the battery status the night before you intend to use your JetForce BT
backpack, and charge the battery if there is less than a full charge. Best practice is
for the battery to be fully charged before heading out.
WEARING THE PACK (FIGURE 3)
Proper fit and secure attachment to your body is critical.
1. Put the backpack on your back with both arms through the shoulder straps.