Accessories; Safety Instructions; General Safety Instructions; Workplace Safety - EFA Z28 Betriebsanleitung

1.4 Accessories

Spring-loaded pulley
Hose kit
Hydraulic unit
Hydraulic fluid
For order numbers of standard equipment and
accessories, please refer to appendix A.2 "List of
spare and wear parts" (page 8).

2. Safety instructions

2.1 General safety instructions

When operating the hook cutter, always
adhere to the following safety instructions:
Before replacing the cutter blades, or carrying
out installation, maintenance or repair work,
disconnect the machine from the supply line.
Only personnel who have been properly trained
and instructed in the safe use of the hook cutter
may handle the tool.
All personnel working with the tool must be
instructed by our specialist technicians.
Installation, maintenance and repair work may
only be carried out by suitably trained and
authorised specialists technicians.
Hook cutters by S&W conform to all relevant
safety standards.

2.2 Workplace safety

1. Keep your workplace tidy. Machines that are not
regularly cleaned and serviced and working
areas that are cluttered lead to an increased risk
of injury!
2. Ensure that the workplace environment is
suitable for the use of the tool and properly
illuminated (min. 500 lx).
3. Prevent unauthorised persons from accessing
your workplace. Concentrate on your work and
use common sense. Do not handle the hook
cutter, if you feel tired and/or find it difficult to
concentrate.
4. Keep the hook cutter in a safe place. While not
in use, store it in a dry place.
5. Work clothing: Do not wear loose clothing or
jewellery, as such items could become ensnarled
in moving machine parts. Wear safety footwear.
Always wear a hairnet!
Schmid & Wezel
D 75433 Maulbronn
6. Avoid an unnatural posture. Make sure that you
stand firmly and do not lose your balance.
7. Handle your tools with care. Use only sharp and
undamaged cutter blades to ensure safe and
efficient working.
8. Use only original EFA blades. Always adhere to
the instructions for the replacement of blades.
See also chapter 4.1.1 "Removing blade" (page
4).
9. Never leave spanners or wrenches attached to
the tool. Before starting it, inspect the vacuum
unit to ensure that all spanners and wrenches
have been removed.
10.Use only original EFA accessories. Warranty is
voided, if other accessories are used. If other
tools inserts or accessories are used, there is
also an increased risk of injury to the operator
and other persons.
11.It is prohibited to modify the machine in any
way. Schmid & Wezel rejects any liability for
damages arising from modified equipment.
3. Commissioning and
operational safety
Workplace
The working area for the operator must have a
size of at least 1.5 m². This area must be kept clear
and may not be shared with any other staff, as the
cutter is moved during operation and could injure
other persons.
The working area must be illuminated with min.
500 lx.

3.1 Commissioning

When connecting the hook cutter
to the pressure supply line, ensure
that it is switched off.
For detailed information, technical data,
parts lists and drawings of the
equipment, see appendix A (page 8).
3.1.1 Spring-loaded pulley
The machine may only operated in conjunction with
a spring-loaded pulley. The pulley must be attached
to a beam above the workplace or the ceiling. For
detailed information on how to install and balance
the spring-loaded pulley, please refer to chapter 4.5
"Adjusting the spring-loaded pulley" (page 5).
Seite/ Page
4/ 9
Ausführung/ Version
2014