Maxwell MW-1056 GY Die Betriebsanweisung Seite 8

ENGLISH
•
Do not carry the thermopot holding it by the
lid opening button.
•
Before pouring out the remaining water, let
the unit cool down, then remove the thermo-
pot lid and pour out the water.
•
To avoid the risk of electric shock, do not
immerse the unit, the power cord and the
power plug of the unit into water or other
liquids.
•
Unplug the unit from the mains if you are not
using it or before cleaning.
•
Do not wash the thermopot in a dishwashing
machine.
•
Before taking the thermopot away for storage
and before cleaning, unplug the unit, pour
out water and let the unit cool down and dry.
•
For children safety reasons do not leave poly-
ethylene bags, used as a packaging, unat-
tended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
• Do not allow children under 8 years of age
to touch the unit body, the power cord or the
power plug during operation of the unit.
•
Do not leave children unattended to prevent
using the unit as a toy.
•
Close supervision is necessary when children
under 8 years of age or disabled persons are
near the operating unit.
• This unit is not intended for usage by children
under 8 years of age.
•
Children aged 8 and over as well as disabled
persons can use this unit only under supervi-
sion of a person who is responsible for their
safety if they are given all the necessary and
understandable instructions concerning the
safe usage of the unit and information about
danger that can be caused by its improper
usage.
• Do not use the unit outdoors.
•
To avoid damages, transport the unit in origi-
nal package only.
•
Never pull the power cord when disconnect-
ing the unit from the mains, take the power
plug and carefully remove it from the mains
socket.
•
Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped. Do not
try to repair the unit by yourself. Contact
MW-1056.indd 8
an authorized service center for all repair
issues.
•
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE USING THE UNIT FOR THE FIRST
TIME
After unit transportation or storage at low
temperature, it is necessary to keep it for at
least two hours at room temperature before
switching on.
•
Unpack the thermopot, remove any stickers
that can prevent unit operation.
•
Check the thermopot for damages, do not
use it in case of damages.
•
Before switching the unit on make sure that
its operating voltage corresponds to the volt-
age in your mains.
• Open the lid (11) by pressing the button (6)
and holding it.
•
Fill the thermopot with water using a suitable
bowl, do not exceed the maximal water level
mark (14) «FULL» on the inner surface of the
thermopot flask.
•
Insert the power cord (17) connector into the
socket (16) on the thermopot body, and the
power plug into the mains socket. The ther-
mopot will be switched to boiling mode, the
«Boiling» indicator (19) will light up on the
control panel (5).
•
After water starts boiling, the thermopot will
be switched to the keep warm mode, the
«Keep warm» indicator (20) will light up.
•
Place a suitable bowl under the spout for
pouring water (4), press the water dispense
button (22) «Dispense» and pour the water
out of the thermopot.
• You can dispense water by pressing the
water dispense ON-button (3) with a mug,
for instance.
•
You can also dispense water using the hand
pump (7) after having previously set the hand
pump lock (10) to the position «
•
To prevent accidental pressing of the hand
pump, set the hand pump lock (10) to the
position « ».
• After use disconnect the unit from the mains
by removing the plug of the power cord (17)
8
».
04.08.2015 12:50:07