Vitek Silky Red Collection VT-1508 R Die Betriebsanweisung Seite 7

Be careful, the steam going out of the pipe is very hot.
• After removing the scale, clean the coffee machine with pure water for 2-3 times (see
section "Preparations before operation).
Trouble shooting
Malfunction
No hot water supply
Coffee is pouring over
the edges of the hold-
er (9)
Technical specifications:
Power supply voltage:
Power consumption:
Water tank capacity:
Specifications subject to change without prior notice.
MINIMUM SERVICE LIFE - 3 YEARS
GUARANTEE
Details regarding guarantee conditions can be obtained from the dealer from whom the
appliance was purchased. The bill of sale or receipt must be produced when making any
claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council
Directive 89/336/EEC and to the Law Voltage Regulation (73/23 EEC)
1508.indd 7 1508.indd 7
- Make sure there is water in the tank (4).
- Switch the coffee machine on by the switcher (14), put the
cup under the steam nozzle (5), and turn on the steam sup-
ply by rotating the control handle (3) downwards to let the air
out. When the steam starts going out of the nozzle (4), turn the
control handle (3) into OFF position (see Pic. 5).
- If after all these operations there is still no hot water supply, ap-
ply to the authorized service center.
- Depending on the grade of coffee powder grinding you can de-
termine from experience the degree of coffee powder ramming
in the filter (8).
- Check out whether the excessive amount of coffee powder is
blocking the appropriate position of the filter holder (9) while
installation.
- There are the crumbs of grinded coffee at the place of the hold-
er installation, remove them.
- If after all these operations coffee is still pouring over the filter
holder edges, apply to the authorized service center.
220-230 V ~ 50 Hz
1000 W
1500 ml
7
ENGLISH
Possible causes
15.05.2007 9:57:09 15.05.2007 9:57:09