Using The Tool - Ingersoll-Rand 2115Ti Bedienungsanleitung

•
Ensure work pieces are secure. Use clamps or vises to
hold work piece whenever possible.
•
Do not carry or drag the tool by the hose.
•
Do not use power tools when tired, or under the influence
of medication, drugs, or alcohol.
•
Never use a damaged or malfunctioning tool or accessory.
•
Do not modify the tool, safety devices, or accessories.
•
Do not use this tool for purposes other than those recom-
mended.
•
Use accessories recommended by Ingersoll-Rand.
The use of other than genuine Ingersoll-Rand replacement parts may result in safety hazards, decreased tool performance, and
increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll-Rand Authorized Servicenter.
WARNING
This is the safety alert symbol.
It is used to alert you to potential
personal injury hazards. Obey all
safety messages that follow this
symbol to avoid possible injury
or death.
Impact Wrenches are not torque wrenches. Connections
requiring specific torque must be checked with a torque meter
after fitting with an impact wrench.
POWER MANAGEMENT SYSTEM
POWER SETTING INDICATORS
MINIMUM

USING THE TOOL

WARNING SYMBOL IDENTIFICATION
AGENCY SYMBOL IDENTIFICATION
European Community Mark
USING THE POWER MANAGEMENT SYSTEM
MAXIMUM
POWER
INDICATOR
(Dwg. TPD1339)
(CONTINUED)
•
Note the position of the reversing mechanism before oper-
ating the tool so as to be aware of the direction of rotation
when operating the throttle.
•
Use only impact sockets and accessories. Do not use hand
(chrome) sockets or accessories.
•
Impact Wrenches are not torque wrenches. Connections
requiring specific torque must be checked with a torque
meter after fitting with an impact wrench.
•
Periodically check the drive end of the tool to make cer-
tain that the socket retainer functions correctly, and that
sockets and drive ends are not excessively worn which
may allow the socket to come off when rotating.
WARNING
Always wear eye protection
when operating or performing
maintenance on this tool.
WARNING
Always wear hearing
protection when operating
this tool.
Indicates compliance with
relevant CE directives.
The 2115Ti series of Impact Wrenches incorporates a
Power Management System that allows the operator to
select four power output settings. These settings range from
minimum power output through maximum power output in
the clockwise direction only. The Air Wrench will always
operate at maximum power output in the counterclockwise
direction, no matter what power output level is selected.
The four power setting indicators of increasing size on the
rear of the housing indicate increasing power output levels,
are for reference only and DO NOT denote a specific power
output. The smallest power setting indicator designates
minimum power output, the two middle power setting indi-
cators denote medium power outputs and the largest power
setting indicator denotes maximum power output. The
power output can be further reduced in clockwise or coun-
terclockwise by using the variable throttle. Air supply sys-
tems which do not deliver adequate air pressure can affect
power output at all settings.
2
WARNING
Read this manual before
operating tool.