English; Cleaning And Maintenance; Smart Calc-Clean System; Sound And Light Calc-Clean Reminder - Philips GC7933/30 Bedienungsanleitung

English

8
- The appliance switches off automatically if it has not been used for another 10 minutes after it enters the
standby mode. The light in the on/off button goes off.
Warning: Never leave the appliance unattended when it is connected to the mains. Always unplug
the appliance after use.

Cleaning and maintenance

Smart Calc-Clean System

Your appliance has been designed with a Smart Calc-Clean system to ensure that descaling and cleaning
is done regularly. This helps to maintain a strong steam performance and prevents dirt and stains coming
out of the soleplate over time. To ensure that the cleaning process is performed, the appliance gives regular
reminders.

Sound and light Calc-Clean reminder

After 1 to 3 months of use, the Calc-Clean light starts flashing and the appliance starts beeping to indicate
that you have to perform the Calc-Clean process )Fig. 14).
Besides that, a second defense step to protect the appliance from scale is integrated: the steam function
gets disabled if descaling is not done )Fig. 1 (. After descaling is done, the steam function will be restored.
This takes place regardless of the type of water used.
Note: The Calc-Clean process can be performed at any time, even when the sound and light reminder is not
activated yet.

Performing the Calc-Clean process with the Calc-Clean container

Warning: Do not leave the appliance unattended during the Calc-Clean process.
Caution: Always perform the Calc-Clean process with the Calc-Clean container. Do not interrupt the
process by lifting the iron up from the Calc-Clean container, as hot water and steam will come out of
the soleplate.
1 Fill up the water tank halfway.
Note: Make sure that the appliance is plugged in and switched ON during the Calc-Clean process.
Place the Calc-Clean container on the ironing board or any other even, stable surface.
Place the iron stably on the Calc-Clean container )Fig. 16).
4 Press and hold the CALC-CLEAN button for 2 seconds until you hear short beeps )Fig. 17).
Note: The Calc-Clean container has been designed to collect scale particles and hot water during the
Calc-Clean process. It is perfectly safe to rest the iron on this container during the entire process.
5 During the Calc-Clean process, you hear short beeps and a pumping sound )Fig. 1 ).
6 Wait approximately 2 minutes for the appliance to complete the process )Fig. 19). When the Calc-Clean
process is completed, the iron stops beeping and the CALC-CLEAN light stops flashing.
7 Wipe the iron with a piece of cloth and put it back on the base station )Fig. 20).
Caution: The iron is hot.
8 As the Calc-Clean container becomes hot during the Calc-Clean process, wait about 5 minutes before you
touch it. Then carry the Calc-Clean container to the sink, empty it and store it for future use )Fig. 21).
9 If necessary, you can repeat steps 1 to 8. Make sure that you empty the Calc-Clean container before you
start the Calc-Clean process.
Note: During the Calc-Clean process, clean water may come out of the soleplate if no scale has
accumulated inside the iron. This is normal.
For more information on how to carry out the Calc-Clean process, refer to the videos in this link:
http://www.philips.com/descaling-iron.