Setting The Clock - auna 10004778 Bedienungsanleitung

Connection
• Connect the power cord (22) to ac outlet
• When you first plug the unit into the mains, the unit will go into standby mode and the standby led
indicator (3) will light up.
• Connect the speaker wire to the speaker jck (21) located on the side of unit.
• Turn on the power (5), if the lcd display (4) is on with backlighting, it means the power supply is nor-
mal. Now your system is ready to play the music.
1 Set unit in standby mode.
2 Press & hold the " Mem/clk-adj " button (13) the first & second digit of " 00 " is flashing on the LCD
display(12). Press skip up or skip down button (15,21) to set the correct hour. Press " Mem/Clk-adj "
button (13) to store the correct hour.
3 The third & fourth digit of " 00 " is flashing, press the skip up or skip down button (15, 21) to set the
correct minutes. Then press " Mem/Clk-adj " button (13) to store the correct minute.
The clock setting mode will automatically quit if no button is being pressed in a period of about 5
seconds after pressing the " Mem/Clk-adj " button. The pre-set time will be re-set completely if dis-
connecting the main power supply. You are recommended to switch the system into standby mode for
convenience usage.

Setting the Clock

15