Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CD programming
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the
"stop
" button (18).
1
Set in CD mode & stop the cd playback.
2
Press the " Mem/Clk-adj " button (13) and " MEM " will appear on LCD display (12).
3
Select a desired track by pressing skip up
4
Press the " Mem/Clk-adj " button (13) to store the track into memory.
5
Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6
When all the desired tracks have been programmed, press " Play/Pause
disc in assigned order.
7
Press " Stop
" button (18) to clear all stored memory.
The programming mode will automatically stop if no button is being pressed in a period of about 10
seconds after pressing the "mem/clk-adj " button.
Playback of MP3 Songs via USB Storage Media or Memory Card
The system is able to decode and playback all MP3 file which stored in the memory media with USB
connecting port or SD/MMC memory card.
1
Set the system at standby mode first or other function except SD or USB mode.
2
Plug-in the USB pen-drive with the face up & make sure it going into completely or insert the me-
mory card in the direction of the arrow as shown in the label on the underside of the memory card
slot cover. Insert straight without bending.
3
Connecting the USB upside down or backwards could damage the audio system or the storage me-
dia (USB thumb drive / SD / MMC card). Check to be sure the direction is correct before connection.
4
Set function button (6) to "
5
The system will start reading the storage media automatically after connecting, and LCD display (12)
will show the total number of MP3 files being detected.
6
Repeat the same playback procedure as playing CD/MP3 disc as above.
Remark
• The system can detect and read the file under MP3 format only at usb/sd mode but not other music
file format.
• If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding format,
some MP3 player may not be able to play via the USB socket. This is not a malfunction of the system.
• USB port does not support connection with USB extension cable and is not designed for communi-
cation with computer directly
Removing of USB / Memory Card
To remove the USB / memory card, turn off the power or switch the function mode to either cd, aux or
tuner first. For USB port – un-plug it by pulling out the usb socket directly, for memory card – press the
memory card inward & then release, now the card being partially eject and you can remove it by hand.
or down
" SD/MMC card or "
button (15, 21).
" button (17) to play the
" Usb mode.
19
Werbung
Inhaltsverzeichnis
