Setting The Clock; Listening To Radio - auna 10004779 Handbuch

1. Set unit in standby mode.
2. Press & hold the " Mem/clk-adj " button (13) the first & second digit of " 00 " is flashing on the LCD
display(12). Press skip up
Mem/Clk-adj " button (13) to store the correct hour.
3. The third & fourth digit of " 00 " is flashing, press the skip up
set the correct minutes. Then press " Mem/Clk-adj " button (13) to store the correct minute.
 The clock setting mode will automatically quit if no button is being pressed in a period of
about 5 seconds after pressing the " Mem/Clk-adj " button.
 The pre-set time will be re-set completely if dis-connecting the main power supply. You
are recommended to switch the system into standby mode for convenience usage.
Manual tuning
1. Press Function button (6) to select " Tuner " mode.
2. Tune to the required station by pressing the tune " + " or " − " button (15,21).
3. Adjust volume up/down button (10,4) to the desired volume level.
Auto tuning
1. Press Function button (6) to select " tuner " mode.
2. Press and hold the tune " + " or " − " button (15,21) for 1-2 seconds and then release.
3. The unit will start seeking automatically and stop until a radio station is reached.
4. Repeat step 2 & 3 until the desired radio station is being reached.
5. Adjust volume up/down button (10,4) to the desired volume level.
Preset stations
You can store up to 20 radio stations in the memory
Set to tuner mode.
1. Turn to the desired radio station by " manual" or " auto " tuning method.
2. Press the Mem/Clk-adj " button (13) until the " MEM " indicator and preset station number are flash on
LCD display (12)
3. Press " Folder / Pre-up
4. Press " Mem/Clk-adj " button (13) again to confirm the setting.
5. Repeat step 1 to 4 to store other stations.
6. Now you can select the presets stations in order by pressing the "Folder/Pre–up
 The pre-set memories will be cancelled completely if dis-connecting the main power supply. You are
recommended to switch the system into standby mode for convenience usage.
 There are 5 seconds for program state, after 5 sec. This state would resume to normal tuner mode
automatically.
 You can overwrite a present station by storing another frequency in its place.
FM-stereo reception
 Press the " St/Mono " button (18) repeatedly, the FM programs are receiving in mono and stereo
mode repeatedly. In particular when stereo signals are weak.
 It is preferable to receive the program in mono.If stereo signal is being received, the stereo
indicator "
Hints for best reception:-
FM : The receiver has a build-in FM wire antenna (24) hanging at the rear cabinet. This wire should be
totally unraveled and extended for the best reception.

SETTING THE CLOCK

or skip down

LISTENING TO RADIO

button (14) to select the desired station memory for storage.
" will appear on LCD display (12) to show FM stereo program is now receiving.
button (15,21) to set the correct hour. Press "
or skip down button (15,21) to
" button (14)