Concept VK5570 Bedienungsanleitung Seite 25

EN
7. When the weighing is finished, switch the unit off by pressing the On/Tare/Off/D- (5) button or the unit will switch
off automatically after 2 minutes.
WEIGHING OF LIQUIDS (VOLUME INDICATION)
The appliance allows weighing liquids with an indication of volume in ml or fl. oz.
Press the Unit button during weighing (4) to indicate the volume of liquid in ml (fl. oz). By pushing the Unit button
again (4) you will select weight in g (oz) again. Unless you press the Unit button (4), the appliance will turn back to
the g (oz) mode after ten seconds.
Setting the density of the weighed liquid:
1. Press and hold the Unit button (4). An arrow at the g and ml or oz and fl. oz will start flashing (Figure 2).
Fig. 2
2. By pressing the On/Tare/Off/D- (5) button, you reduce the density of the weighed liquid, while by pressing the
Preset/D+ (3) you increase the density.
3. Confirm the setting by pressing the Unit button (4). Unless you confirm the density setting within 10 seconds, the
appliance will return to the weighing mode without saving the preset values.
Note: The preset value remains in the memory until the battery is empty or removed.
WEIGHING WITH OWN-DETERMINED WEIGHT UNITS
The appliance allows setting your own-determined weight units (e.g. 1 unit = 300 g, 2 units = 600 g, etc.). The minimum
weight of 1 own-determined weight unit is 200 g. If you attempt to insert a weight smaller than 200 g, the „E" symbol
will appear on the display (Fig. 3).
Fig. 3
a) inserting an own-determined weight unit into the memory
1. Push the On/Tare/Off/D- (5) button to switch on the unit.
2. Press the Preset/D+ (3) button to select the own-determined weight unit mode.
3. After the first insert of the own-determined weight unit, the „ -" symbol will be displayed (Fig. 4) If you re-write an old
setting, the „ 0.00" symbol will be displayed (Fig. 5).
Fig. 4
VK5570
Fig. 5
23