Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
· Please read all instruction manuals before use and
save it for future references.
· Before first switching on check that voltage
indicated on the rating label corresponds to the
mains voltage in your home.
· For home use only. Do not use for industrial
purposes. Use the steam iron only for its intended
use.
· Do not use outdoors or in damp area.
· Do not immerse the steam iron and cord in water or
other liquids.
· Never pull the cord while disconnecting from the
power outlet; instead, grasp the plug only and pull
to disconnect.
· Do not allow the cord to touch sharp edges and hot
surfaces.
· Always unplug the steam iron from the power
supply when filling with water or emptying and
when not in use.
· Do not operate the steam iron with damaged cord
or plug, or after the appliance malfunctions, or has
been dropped or damaged in any manner. To avoid
the risk of electric shock, do not disassemble the
steam iron; take it to a service center for
examination, repair or mechanical adjustment.
· This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless
supervision or instruction concerning use of the
appliances by a person responsible for their safety.
· Children should be supervised to ensure that they
do not play with the appliance.
· Do not leave the iron unattended while hot or
connected or on an ironing board.
· While ironing is interrupted, stand iron on heel rest
only, do not place the steam iron on metal or rough
surfaces.
CAUTION: To avoid a circuit overload, do not operate
another high wattage appliance on the same circuit.
BEFORE THE FIRST USE
· Some parts of the steam iron have been slightly
greased and as a result the iron may slightly smoke
when switched on for the first time. After a short
time this will cease.
· Remove protection cover from the soleplate and
clean it with soft cloth.
HOW TO USE
SETTING TEMPERATURE
· Always check whether a label with ironing
instructions is attached to the article to be ironed.
Follow these instructions in all cases.
· Turn the temperature control dial round to set the
appropriate temperature indicated in the ironing
instructions or in the fabric label.
LABEL
TYPE OF TEXTILE
Do not iron this article
1, 2
Synthetics, Nylon, Acrylics, Polyester
3, 4
Silk, Rayon
5
Wool
6
Cotton, Linen
www.scarlett.ru
they
have
been
given
· Insert the mains plug into the wall socket.
· Allow the iron to heat up for 90 seconds.
WATER TANK FILLING
· Unplug the iron before filling.
· Hold the steam iron in horizontal position.
· Slowly pour water through the water inlet.
· Do not fill higher than mark on the water tank, in
order to avoid spilling water out.
NOTE: Your steam iron is designed to use tap water.
However, if the water is very hard, it is advisable to
use distilled water.
NOTE: Do not use chemically de-limed or perfumed
water.
NOTE: If you have too hard water,it is advisable to
use only distilled or demineralized water.
· The water tank should be emptied after each use.
SPRAYING
· As long as there is enough water in the water tank,
you may use the spray button at any temperature
setting either on steam or dry ironing.
· Press the spray button several times to activate the
pump while you are ironing.
STEAM IRONING
· The Smart Steam system automatically produces
steam when you turn the temperature control dial
between
and
· With the unit unplugged, fill the steam iron with
water.
· Stand the steam iron on its heel rest in an upright
position on an iron-safe surface and plug in.
· Set the temperature control dial to the
position.
· Allow the iron to heat up for 90 seconds.
· When finished, turn the temperature dial
counterclockwise to the minimum position and
unplug the appliance from the power supply.
CAUTION: Avoid coming in contact with ejected
steam.
DRY IRONING
· For dry ironing turn the temperature control dial to
positions.
· To iron without steam at high temperature settings,
empty the water reservoir.
CAUTION: If the steam iron has been used for a long
time, is hot and there is no water. Do not refill it
with water until the steam iron cools down.
BURST OF STEAM
· The burst of steam feature provides additional
steam for removing stubborn wrinkles.
· Turn the temperature control dial to
· Press the powerful steam button to release the
burst of steam.
NOTE: To prevent water leakage from the soleplate,
do not keep the powerful steam button pressed for
more than 5 seconds.
NOTE: For the best steam quality, do not use more
than three successive bursts each time, because
the iron will cool.
VERTICAL STEAM
· Ensure that there is enough water in the water
tank.
· Stand the steam iron on its heel rest on an iron-
safe surface and plug it.
· Set the temperature control to maximum position.
4
positions.
position.
SC-1132S
IM001
Werbung
