Main Functions - Futurelight PHW-265 Bedienungsanleitung

Main functions

- Main menu 0
- DMX address setting, Slave setting
- DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
• Select "VALU" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], adjust the DMX address by pressing [UP] or [DOWN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order return to main menu.
- Slave setting
With this function, you can define the device as slave.
• Select "SLAV" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DOWN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- DMX address setting via controller
With this function, you can adjust the desired DMX-address via an external controller.
This function can only be activated when the DMX-value of all other channels is set to "0" on the
controller.
• Select "EBOC" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DOWN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address
between 1 and 255. When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting
address to 57, set channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the
starting address to 420, set channel 1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is
set.
Run
- Program Run, Master setting
With the function "RUN", you can run the internal program. You can set the number of steps under Step.
You can edit the individual scenes under Edit. You can run the individual scenes either automatically
(AUTO), i.e. with the adjusted Step-Time or sound-controlled (SOUN). The selection "ALON" means
Stand Alone-mode and "MAST" that the device is defined as master.
• Press [MODE/ENTER] to enter the main menu "MODE" (display flashing)
• Press [MODE/ENTER] and select "ADDR", "RUN" or "DISP" by pressing
[UP] or [DOWN].
• Press [MODE/ENTER] for selecting the desired sub menu.
52/116 51838710_V_1_1.DOC