Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wireless DMX
For wireless data transmission you need a DMX-controller, a wireless sender and a wireless receiver or
devices with wireless receiver, respectively.
If a device with wireless receiver is connected with a DMX-controller via cable, the device will be controlled
by the cabled controller and not by the wireless transmitter.
Please note: Never connect a cabled controller if the device with wireless receiver is controlled by the
wireless transmitter! Otherwise danger of interferences.
The wireless receiver has an internal memory function. If the device is switched off and on again, the
receiver automatically logs into the transmitter.
Meaning of the LEDs and their colours
Wireless sender status-LED
Red/green flashes rapidly: Login-mode, every free wireless receiver is logged into the wireless sender.
Green permanently lit: the DMX-signal is present and transmitted.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
Wireless receiver sender status-LED
Red permanently lit: not logged into a wireless sender (free).
Red/green flashes rapidly: Login-mode, the wireless receiver logs into the wireless sender.
Green permanently lit: The wireless receiver is logged into the wireless sender. The DMX-signal is present
and received.
Red/green flashes slowly: no DMX-signal, the radio link is being held.
Installation of a wireless DMX-system
1. Connect the DMX-controller with the wireless sender.
2. Switch on the DMX-controller, den the wireless sender and the wireless receiver or the devices with
wireless receiver, respectively.
3. Press and hold the sender's Function-button for 3 seconds. During the Login-mode, the sender's and
receiver's red/green LEDs flash rapidly for approx. 5-10 seconds. As soon as the DMX-signal is transmitted,
the sender's and receiver's green LED is permently lit. If there is no DMX-signal, the sender's and receiver's
red/green LEDs flash slowly.
4. Control the device via your DMX-controller.
Log out one wireless receiver
The procedure of logging out one wireless receiver depends on the respective device. The FUTURELIGHT
projectors with wireless receiver are logged out via the Control Board, menu Set-WDMX-Rest. The
FUTURELIGHT WDR-1 wireless receiver logs out by pressing and holding the receiver's Function-button for
about 3 seconds. As soon as the wireless receiver is logged out, the receiver's red LED is permently lit.
Log out all wireless receivers from the sender
Press and hold the sender's Function-button for at least 5 seconds. As soon as the wireless receivers are
logged out, the receiver's red LED is permently lit.
46/116
51838710_V_1_1.DOC
Werbung
Inhaltsverzeichnis
