Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the fixtures is secure.
strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER OF FIRE!

Use 2 appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
DANGER TO LIFE!
CAUTION!
The Moving-Head can be placed
directly on the stage floor or rigged in
any orientation on a truss without
altering its operation characteristics
(see the drawing).
The fixture's base enables to be
mounted in two ways.
For overhead use (mounting height
>100 cm), always install a safety-rope
that can hold at least 12 times the
weight of the fixture. You must only
use safety-ropes with quick links with
screw
through the hole on the bottom of the
base and over the trussing system
etc. Insert the end in the quick link
and tighten the fixation screw.
The maximum drop distance must
never exceed 20 cm.
A safety rope which already hold the
42/116
cap.
Pull
the
safety-rope
51838710_V_1_1.DOC

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis