Inhaltsverzeichnis
Werbung
■ Setting the zigzag width for end backtack stitches (additional DIP switch function)
(Be sure to turn off the power before changing any of the DIP switch settings. Refer to page 163.)
Zigzag width
d
Zigzag width for end
backtack stitches
q
C
A
UTO
TEST
TEST
S E T
E T
w
t
q
C
A
UTO
TEST
TEST
S E T
E T
w
t
Turning the end backtack function on and off
The condition changes as shown below each time the end backtack key e is pressed.
•
End backtacking is carried out when the end backtack indicator r is illuminated.
•
Zigzag width display, etc.
|
8 8 8 8
Illuminated
Number of end
backtack stitches
C
＊ ＊
＊ ＊
1 2 3 3 4 4
1 2
6 6
8 8
5 5
7 7
9 9
PAT T ERN
S
S
ROM
E
F
E
L
r
r
e
1 2 3 3 4 4
1 2
6 6
8 8
9 9
5 5
7 7
PAT T E R N
S
S
ROM
E
F
E
L
r
r
e
Number of end backtack
stitches
C
C
8 8 8 8
LZ2-B855E,B856E
7. USING THE OPERATION PANEL
7. VERWENDUNG DER BEDIENUNGSTAFEL
7. UTILISATION DU PANNEAU DE COMMANDE
7. USO DEL TABLERO DE CONTROLES
When DIP switch 2-5 inside the control box is set to OFF,
the zigzag width for end backtack stitches can be set sepa-
rately from the normal zigzag width. (You must set the
start backtack zigzag width at this time too. Be sure to
make this setting if carrying out start backtack sewing
too.)
1. If the LED display q is illuminated steadily, press the
SET key w so that the LED display q flashes.
2. Press the end backtack key e.
The indicator r will illuminate, and C** will flash
on the LED display q as the current setting for the
number of end backtack stitches.
(For example, C+5 represents 5 end backtack
stitches.)
3. If changing the setting for the number of end backtack
stitches, press the △ and ▽ selection keys t to
change the setting.
4. Press the end backtack key e once more.
The indicator r will remain illuminated, and d**
will flash on the LED display q as the current setting
for the end backtack stitch zigzag width.
The setting is displayed in units of 0.1 mm.
(For example, d10 represents a zigzag width of 1.0
mm for the end backtack stitches.)
5. Press the △ and ▽ selection keys t to change the
zigzag width setting.
6. Press the SET key w.
The zigzag width set for end backtacking will be ac-
cepted, and the LED display q will stop flashing and
illuminate steadily.
7. Carry out sewing. When the treadle is depressed back-
ward, the end backtack stitches will be sewn. (For the
B856E, the thread will then be trimmed.)
Zigzag width for end backtack
stitches
d
d
8 8 8 8
Illuminated
Zigzag width display
|
8 8 8 8
Off
102
Werbung
Inhaltsverzeichnis
Fehlerbehebung
