Operation; Voltage Supply; Storage Battery Operation; Opening And Closing - Bosch DCU 220 Betriebsanleitung

en 22 | DCU 220 | Initial commissioning
i
You can also skip this step and perform it later un-
der Win 10.
5. When selecting a network, enter the network securi-
ty code via the USB keyboard or on-screen keyboard.
 A connection with the network is established.
6. In the "Get going fast" window, select <Use express
settings>.
7. In the "Select connection type" window, select
<Join a local active directory domain>.
 The "Create account for this PC" window.
8. Enter user name via on-screen keyboard or USB
keyboard.
i
We recommend you use a security password for
DCU 220.
9. Press <Next> to install the Windows operating
system.
 The Win 10 start screen appears after some time.
"
The adjustment of the Windows operating system is
complete.
4.5

Software installation

Depending on the use, the Bosch user software must
then be installed. The corresponding installation inst-
ructions can be found in the directions for the respecti-
ve Bosch products.
|
1 689 989 321 2019-06-04
5.

Operation

5.1

Voltage supply

The DCU 220 can be operated with the following volta-
ge supply:
R
Storage battery
R
Power supply unit
!
Only use the power supply unit included in the scope of
delivery.
5.2

Storage battery operation

i
For additional information on storage battery opera-
tion, see the "User manual DCU 220" on the desk-
top.
5.3

Opening and closing

Follow the steps below to open the DCU 220:
1. Pull the latch () upward to release the clip ().
2. Pull the clip downward.
3. Open the screen ().
Abb. 10: Opening DCU 220
Follow the steps below to close the DCU 220:
1. Close the screen.
2. Push the latch upward.
3. Engage the clip in the cover.
4. Push the latch downward until it locks in place.
Robert Bosch GmbH