Switching On; Turning Off And Standby Mode; Touch Screen With Stylus; Operating In Tablet Mode - Bosch DCU 220 Betriebsanleitung

5.4

Switching on

!
To avoid the formation of condensed water, allow the
DCU 220 to adjust to ambient temperature before
switching on the DCU 220!
1. Turn on the DCU 220 by pressing the
than 2 seconds.
i
The start screen is always displayed after switch-on.
The applications displayed can be selected on the
start screen.
2. Select the mode in which you want to work.
3. Start the application that you want to use.
CAUTION – Risk of injury from triggering
the airbag with attached DCU 220!
If the DCU 220 is attached to (suspended
from) the steering wheel, injuries could result
from unintentionally triggering the airbag.
¶
Never attach the DCU 220 to the steering
wheel.
5.5

Turning off and standby mode

Weitergabe sowie Vervielfältigung der Zeich- Rz 10
nungen sind nicht gestattet und müssen
streng vertraulich behandelt werden. Alle ( )
Rechte sind bei ads-tec GmbH nach DIN 34. Druckdatum/ print date: 17.12.2010
strictly confidential according to DIN 34. File:Airbag Lenkrad + TT13 Doku 130
i
Turning off and power management are described in
the user manual.
5.6

Touch screen with stylus

i
Operation is described in the user manual.
5.7

Operating in tablet mode

The DCU 220 can be used as a conventional laptop as
well as in tablet mode. In tablet mode, the DCU 220 is
operated using a stylus or your fingertip and virtual key-
board instead of the keyboard and touchpad (mouse).
1. Open the DCU 220 until the screen is nearly perpen-
dicular to the keyboard.
2. Rotate the screen 180° counterclockwise.
Robert Bosch GmbH
key longer
!
Do not rotate the screen more than 180°, and do not
rotate it clockwise.
3. Fold the screen downward so that the screen display
points upward and the screen lies securely on top
(note the side guides).
4. Push the latch upward.
5. Engage the clip in the cover.
6. Pushed the latch downward until it locks in place.
5.8

Printing

You can connect a printer (such as a PDR 377) via the
USB port of the DCU 220.
i
Refer to the printer manufacturer's information for
details of printer drivers and installation.
i
Information on printing can be found in the online
help for the Bosch applications.
5.9

Camera

i
Operation is described in the user manual.
Operation | DCU 220 | 23
|
1 689 989 321
en
2019-06-04