Additional Equipment - Fral FSC14.1SC Bedienungsanleitung

How is the m² or
m³ data of the
manufacturer
calculated
E1
E1
E2
E4
DF

ADDITIONAL EQUIPMENT

The unit can be equipped with additional accessories and additional external piloting.
1. Read the installation of a movable grille outlet (free air outlet without inserting tubes)
2. Air Comfort Kit - control panel with LED display equipped with a temperature sensor, remote control and a 3
meter long cable with plug.
3. Air Sensor Kit - control-measuring unit equipped with a temperature sensor and 3 or 6 meter long cable with
plug (Allows control of the air conditioner set on the outside of the room to be cooled from the inside)
The list of additional equipment in available on ourwebsite: www.uni-lux.eu
Please contact the dealer to get detailed information.
Room temperature
outside the function range:
Room temperature
inside the function range:
Temperature of the
cooling agent lines too
high or too low
Water tank full
Defrosting mode
www.uni-lux.eu
27
The m² or m³ data of the manufacturer
for the various units are average
values related to a room height of 2.5
metres. It must be considered that
such data can be clearly underscored
or exceeded under certain
circumstances. Circumstances which
work against efficiency of the units
include e.g. bad insulation of the
building, large window areas, south
facing, attic apartment, many
additional heat sources, such as e.g.
number of persons, EDP, light, kitchen
units, washing units etc.
Observe all data in these operating
instructions concerning function
range.
New measurement of start
temperature. Please switch the unit off
and start it again after approx. 30
minutes. If the error occurs
continuously, the unit requires
specialist inspection.
Temporary error on measuring output
temperature.
Please switch the unit off and start it
again after approx.
30 minutes. If the error occurs
continuously, the unit
requires specialist inspection.
If the water tank is full, the warning
sign "E4" appears in the display. To
restart operation of the unit, please
remove the plug of the condensation
water outlet to allow water to leak out.
Please use an appropriate
collection tank. When the water has
been completely removed, please start
the TRANSPORT unit again. The
unit can now be used as usual.
This procedure is completely normal
and protects the system from icing and
failure. The unit starts automatically
after approx. 15 minutes again
(depending on the function setting).
This procedure repeats itself
regularly.
UK