Cleaning And Maintenance - Fral FSC14.1SC Bedienungsanleitung

CLEANING AND MAINTENANCE

Please remove the power plug from the socket before cleaning the unit.
COARSE FILTER
The air filters on the side of the unit can be simply removed by pulling the frame sidewards. When cleaning,
use a vacuum cleaner with brush or wash the filters under running, warm water and dry them with a soft cloth!
Please clean the coarse filters before initial use, and regularly twice a week when in use or more often depending
on dust concentration.
ERROR MESSAGES
The mobile air conditioner is equipped with a 3-minute compressor-delay system which means
the compressor needs 3 minutes to start. This affects the switching on of the unit (POWER) as well as switching
over from one function to the next, e.g. dehumidify to cooling or heating.
ERROR/PROBLEM
Can I switch the
unit on immediately after
unpacking it?
When switching
on the unit I sense a smell. What
should I do.
Can I operate the
unit WITHOUT the
extract air hose.
At which intervals
should the activated carbon
filter of the unit be replaced? (option)
How can I
increase the efficiency of the
unit?
Compressor does
not activate
unit deactivates
CAUSE
Production-related
cause or incorrect
storage of unit at e.g.
dusty areas.
www.uni-lux.eu
26
REMEDY
No.
The unit must be placed upright for at
least 2 hours
after every transport. Otherwise the
compressor may be
damaged and there is no capacity.
Run the unit for ½ a day. The smell will
disappear after a
while. In the case of intensive odour
development, air the
room.
No.
To achieve temperature adjustments,
surplus heat or
coldness must be discharged.
To use the purpose of the filter fully, it
should be
replaced every 6 months. (option)
External circumstances exist which
may impact the efficiency of the unit.
Room insulation, use of wall/window
adapter, ratio of window space (solar
radiation), operation of electrical units
in the room (EDP), presence of several
persons in the room. You can
increase the efficiency of the unit
accordingly by adjusting such
circumstances.
Depending on ambient temperatures
and unit type it may
take approx. 10 minutes after starting
the compressor
until the cooling/heating capacity is
reached.
On reaching the set required
temperature, the unit
switches off automatically. Check
manual setting of the
required temperature as well as the
TIMER setting.
UK