Error Message - HP Designjet 3D Printer Einführende Informationen

Table 1. Error Messages

Error message

Error code on display panel
Build Error
Can't Find Home
Check Modeling Base
Material Error
Filament error
Material Error
Filament blocked
Material Error
Carrier invalid
Material Error
Filament broken
Load Error
Filament blocked
Load Error
Purge failed
Unload Error
Unload failed
Model/Support Jam
in head
clear before resuming
Pausing
Contact Technical Support.
Partial or bad part file sent to system. Check STL file validity in CAD
software; reprocess STL in HP Designjet 3D Software Solution and re-
download to system.
1.Verify a modeling base is inserted.
2.Modeling base may be used or defective – replace.
1.Remove the carrier and verify material is coming out of the material
guide.
2.Verify material pulls freely from the carrier.
3.Verify the material tubes are free of material.
4.Reload material.
1.Remove carrier and verify material pulls freely from carrier.
2.Verify the material tubes are free of material.
3.If the path is not obstructed, clean debris from Filament Present (FP)
Switch. See Maintenance section in User Guide.
4.Reload material.
1.Remove carrier and verify it is not empty.
2.Replace material spool.
3.Reload material.
1.Remove the carrier and verify material is coming out of the material
guide.
2.Verify material pulls freely from the carrier.
3.Verify the material tubes are free of material.
4.Reload material.
1.Remove the carrier and verify material is coming out of the material
guide.
2.Verify the material pulls freely from the carrier.
3.Verify the material tubes are free of material.
4.If the path is not obstructed, clean debris from Filament Present (FP)
Switch. See Maintenance section in User Guide.
5.Reload material.
1.Remove the carrier and verify material is coming out of the material
guide.
2.Verify the material pulls freely from the carrier.
3.Verify the material tubes are free of material.
4.Check for and clear any excess material build up around the tips.
Remove the carrier and verify the material tubes are free of material.
See Troubleshooting section in User Guide.
1.Press .
Resume
2.Unload the material carriers and reinstall.
8
Recommendation