Switching On And Off - Parkside Performance PSSAP 20-Li B2 Bedienungs- Und Sicherheitshinweise

Removing the saw blade
(Fig. G)
Turn the chuck ring 2 in a counter-clockwise
¾
direction.
Pull the saw blade out of the saw blade
¾
holder 3 .
Release the chuck ring 2 and let it return to
¾
its original position.
NOTE
For certain work, the saw blade can also
u
be inserted after turning through 180°.
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product.
m
CAUTION! RISK OF INJURY!
Before switching on the product: Ensure
u
the saw blade is not in contact with the
workpiece.
Ensure your stance is stable. Always hold
u
the product's front 9 and rear handle 7
firmly with both hands while working
(Fig. H).
Keep your hands away from the saw
u
blade when the product is in operation.
NOTE
The on/off switch 6 cannot be locked.
u
(Fig. I)
Switching on: Release the switch lock 5
¾
by pushing it in on the left or right side.
Press and hold the on/off switch 6 .
Regulate the speed as required (see "Speed
control").
Switching off: Release the on/off switch
¾
6 .
When releasing the on/off switch, the switch
lock 5 moves back into its original position.
˜ Speed control
By using the on/off switch 6 , you can
¾
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light 10
to illuminate the immediate working area to
improve visibility in poorly lit areas.
The LED work light 10 lights up automatically
¾
as soon as the product is switched on.
NOTE
The LED work light 10 stays on for an
u
additional approx. 10 seconds after
switching off the product.
Speed
Lower speed
Higher speed
GB/IE 37