Changing The Oil - Dometic ePower T Montage- Und Bedienungsanleitung

ePower T, ePower T LPG
11.3 Finishing maintenance work
➤ Connect the generator to the positive terminal of the supply battery.
➤ Switch the generator to standby with the main switch (fig. 4 1, page 4).
➤ Close the generator cover.
11.4

Changing the oil

!
CAUTION!
Hot oil can cause burns.
A
NOTICE!
Only dispose of used oil at a specialist recycling station and
observe the local laws for environmental protection.
You may use the following oil:
 API SG or SF grade oil for four-stroke engines
 SAE 10W-30 grade oil (can be used at any temperature)
 SAE 0W-40 oil (recommended to improve engine start in extreme low
temperature climates)
 Oil with single grade oil viscosity
Select the appropriate viscosity according to the average temperature
on-site.
Change the oil as follows (fig. k, page 16):
➤ Allow the generator to run until warm so that the oil can drain off faster and
completely.
➤ Place a suitable receptacle under the drain plug (1).
➤ Take out the drain plug (1).
✓ The oil drains off.
➤ Pour fresh oil into the nozzle.
The amount of oil is: 0.6 l.
EN
Servicing the generator
41