Yamaha Disklavier E3 Bedienungsanleitung Seite 4

4
Insert the USB flash memory including the update program
into the USB port of the control unit.
USB flash memory
The update program is ready to be installed.
Update the firmware following the procedures in "Updating the
Disklavier" on page 4.
Updating the Disklavier
Update the Disklavier firmware using the update program you downloaded.
1
While holding [PLAY/PAUSE] on the control unit, press
[ON/OFF].
+
Hold
The current version information of each module appears one after
the other.
2
Make sure that the update program is prepared, then press
[ENTER] on the control unit.
The starting screen appears.
3
Press [ENTER] on the control unit again.
After a while, the update confirmation message of each module
appears.
English
USB port
CTRL system v2.20
*UPDATE
EW ITE SYSTEM P OG AM
(ENT)
v2.20  v3.00
MC -SURE? (PLAY,STOP)
(ENT)
Updating the Disklavier
Note:
Depending on the version or
specification of the Disklavier, the
actual indications for the version and
module names may differ from ones
depicted here.
Continued on next page
4