Electrolux ENA38500W Benutzerhandbuch Seite 33

m1 m2
m3
8. Remove using a tool the cover (b1). Un-
screw the lower hinge pivot (b2) and the
spacer (b3) and place them on the op-
posite side.
9. Re-insert the cover (b1) on the opposite
side.
10. Remove the stoppers (d1) and move to
the other side of the doors.
11. Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
12. Fit the pin of the middle hinge (m5) into
the left-hand hole of the lower door.
13. Re-insert the lower door on the pivot pin
(b2).
14. Re-screw the middle hinge (m1) on the
opposite side . Do not forget the plastic
spacer (m2) inserted under the middle
hinge.
m5
m4
b1
b2
b3
15. Re-insert the upper door on the middle
hinge (m5).
Make sure that the edges of the doors
run parallel to the side edge of the appli-
ance.
16. Position and fix the upper hinge (you can
find them in the instruction for use bag)
on the opposite side (t6).
t6
17. Insert the panel (t7) (that can be found in
the instruction for use bag).
18. Open the upper door, attach the top
cover (t2) using screws (t1). Insert the
magnet (d7). Close the door.
19. Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fit-
ting of the gasket or accelerate this process
by heating up the part involved with a normal
hair drier.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.
electrolux 33
t7