Werbung
6.1 Install child car seat with ISOFIX connector + Top tether
6.1.1 Install child car seat
6.1.1.1 Adjust child car seat to position 3 by pulling reclining adjust lever under the
seat. (fig. 2)
6.1.1.2 Pull rotation lever with one hand(a) and grab backrest with another hand (b)
to rotate 180 degree in left or right direction to make backrest in rearward facing.
Adjust backrest reclining position to R. (fig. 3)
6.1.1.3 Place child car seat facing rearward.(fig. 4)
6.1.1.4 Release ISOFIX connector by pressing red part in ISOFIX connector button a,
and then button b and pull ISOFIX button out. (fig. 5)
6.1.1.5 Insert both ISOFIX connectors into ISOFIX anchorage points until you hear
clear „click" and ISOFIX connector indicator show green color. Then push child car
seat closely to fit closely vehicle backrest. (fig. 6)
6.1.1.6 Pull out Top tether, get the strap through the gap under vehicle headrest
and safety belt guide slot on right or left side.Hang Top tether hook on anchorage
points which please refer to proposed Top tether anchorage points in vehicle use
manual. (fig. 7)
6.1.1.7 Tighten belt until indicator shows green. Shake the child seat to check if the
belt is tight or not. If need to release, press the button of adjuster and pull belt in
opposite negative direction, then get hook out after Top tether released. (fig. 8)
6.1.2 Secure child in child car seat
6.1.2.1 Release shoulder belt by pressing adjuster button with one hand and pull
shoulder belt with another hand until shoulder belt can't be pulled. (fig. 9)
6.1.2.2 Open buckle by pressing button of buckle and let two tongues out. (fig. 10)
6.1.2.3 Place child in child car seat. (fig. 11)
6.1.2.4 Adjust headrest by pulling headrest adjust lever upward to the position that
fits your child. (fig. 12)
WARNING!
Adjust shoulder pads height slightly lower than child shoulders when child car
seat is used rearward facing and use adult index finger as reference. (fig. 12A)
6.1.2.5 Put child arms through shoulder pads, guide two buckle tongues together
and engage them into buckle until you hear a clear „click". (fig. 13)
6.1.2.6 Tighten adjuster belt by pulling it forward and check if buckle is locked.
(fig. 14)
ATTENTION!
1. Make sure buckle doesn't get loose when pulling adjust belt.
2. Make sure there is no twists of belt.
47
Werbung
