Herunterladen Diese Seite drucken

BabySafe Labrador Bedienungsanleitung Seite 48

Werbung

6.2 Install child car seat with 3 point safety belt
6.2.1 Install child car seat
6.2.1.1 Place child car seat facing rearward. (fig. 4)
6.2.1.2 Open buckle, remove inner cushion, pull out vehicle safety belt. (fig. 15)
6.2.1.3 Guide 3 point safety belt through lap belt guides and round back of child car
seat.Insert buckle tongue in buckle. Put inner cushion in child car seat and tighten
vehicle shoulder belt according to arrows shown. Check if child car seat is firmly
installed and make sure there is no twist of belt. (fig. 16)
WARNING!
Any other force point is forbidden to use except the points indicated in user
manual. Please contact child car seat retailer or manufacturer for any doubt.
Note: Vehicle safety belt should not be slack and twist during the whole instal-
lation process.
6.2.2 Secure child in child car seat
6.2.2.1 Release shoulder belt by pressing adjuster button with one hand and pull
shoulder belt with another hand until shoulder belt can't be pulled. (fig. 9)
6.2.2.2 Place child in child car seat. (fig. 17)
6.2.2.3 Adjust headrest by pulling headrest adjust lever upward to the position that
fits your child. (fig. 12)
WARNING!
Adjust shoulder pads height slightly lower than child shoulders when child car
seat is used rearward facing and use adult index finger as reference. (fig. 12A)
6.2.2.4 Get child arms through shoulder pads, guide two buckle latches together
and engage into buckle until you hear a clear „click". (fig. 18)
6.2.2.5 Tighten adjuster belt by pulling it forward and check if buckle is locked.
(fig. 19)
ATTENTION!
1. Make sure buckle doesn't get loose when pulling adjust belt.
2. Make sure there is no twists of belt.
6.3 Install child car seat with ISOFIX connector + 3 point safety belt
6.3.1 Install child car seat.
6.3.1.1 Place child car seat facing rearward. (fig. 4)
6.3.1.2 Release ISOFIX connector by pressing ISOFIX connector button a, and then
button b and pull ISOFIX button out. (fig. 5)
6.3.1.3 Insert both ISOFIX connector into ISOFIX anchorage points until you hear
48

Werbung

loading