Herunterladen Diese Seite drucken

BabySafe Labrador Bedienungsanleitung Seite 53

Werbung

clear „click" and ISOFIX connector indicator show green color. Push child car seat to
fit vehicle backrest closely. (fig. 29)
8.2.2 Secure child in child car seat.
8.2.2.1 Place child in child car seat. (fig. 45)
8.2.2.2 Adjust headrest height to make shoulder belt slightly higher than child sho-
ulders. (fig. 12B)
8.2.2.3 Guide diagonal belt section of 3 point safety belt through diagonal belt
guide and guide lap belt section through lap belt guide. Insert buckle tongue into
vehicle buckle until you hear a clear „click". (fig. 46)
Note: Any slack and twist of vehicle belt is not allowed for installation.
8.3 Install child car seat and secure child with 3 point safety belt.
8.3.1 Place child car seat facing forward. (fig. 43)
8.3.2 Pull reclining lever and adjust backrest to position 1 ONLY. (fig. 44)
ATTENTION!
Only position 1 is allowed to use for Group II, III.
8.3.3 Place child in child car seat. (fig. 47)
8.3.4 Adjust headrest to make shoulder belts slightly higher than child shoulders. (fig. 12B)
8.3.5 Guide diagonal belt section of 3 point safety belt through diagonal belt guide
and guide lap belt section through lap belt guide. Insert buckle tongue into vehicle
buckle until you hear a clear „click". (fig. 48)
Note: Any slack and twist of vehicle belt is not allowed for installation.
9. Remove child car seat
9.1 Pressed ISOFIX connector button with one hand, push child car seat with another
hand in the meantime so ISOFIX connector at one side can be released. Repeat the
operation for another side, then you can remove child car seat. (fig. 49)
ATTENTION!
If you are not able to press red button, push child car seat with big force, then
press the red button again, you can release ISOFIX connector.
9.2 Press ISOFIX connector button(a) in order to retract ISOFIX connector. (fig. 50)
10. Remove the cover
10.1 Remove headrest cover.
10.1.1 Hold the edge of cover and remove headrest cover. (fig. 51)
10.2 Remove backrest cover.
10.2.1 Hold the edge of cover and remove backrest cover. (fig. 52)
Note: Reverse the operation if you want to put on the cover.
53

Werbung

loading