Werbung
clear „click" and ISOFIX connector indicator show green color. Then push child car
seat to fit vehicle backrest closely. (fig. 6)
6.3.1.4 Open buckle, remove inner cushion and grab 3 point safety belt. (fig. 20)
6.3.1.5 Guide 3 point safety belt through lap belt guides and round back of child
car seat. Insert buckle tongue in buckle. Put on inner cushion in child car seat and
tighten diagonal belt section according to arrows shown in fig. 7. Check if child car
seat is firmly installed and make sure there is no twist of belt. (fig. 21)
WARNING!
Any other force point is forbidden to use except the points indicated in user
manual. Please contact child car seat retailer or manufacturer for any doubt.
6.3.2 Secure child in child car seat.
6.3.2.1 Release shoulder belt by pressing adjuster button with one hand and pull
shoulder belt with another hand until shoulder belt can't be pulled. (fig. 9)
6.3.2.2 Place child in child car seat. (fig. 22)
6.3.2.3 Adjust headrest by pulling headrest adjust lever upward to the position that
fits your child. (fig. 10)
WARNING!
Adjust shoulder pads height slightly lower than child shoulders when child car
seat is used rearward facing and use adult index finger as reference. (fig. 10A)
6.3.2.4 Put child arms through shoulder pads, guide two buckle tongues together
and engage them into buckle until you hear a clear „click". (fig. 23)
6.3.2.5 Tighten adjuster belt by pulling it forward and check if buckle is loc-
ked. (fig. 24)
ATTENTION!
1. Make sure buckle doesn't get loose when pulling adjust belt.
2. Make sure there is no twists of belt.
7. Install child car seat and secure child for Group I (9–18kg)
There are three ways to install child car seat as below:
• Install child car seat with ISOFIX connector and 3 point safety belt (fig. 25A)
Direction
Install child car seat
Secure child in child car seat
Rearward facing
ISOFIX connector + 3 point safety belt
5 point harness system
49
Werbung
