Command Mode; Command Format A; Command Format B - KERN KXS-TM Betriebs Und Installationsanleitung

13.5 Command Mode

RS 485:
 During input „Id 00"(function RS1 12, see chapter 12.12) the instruction format is
the same as with RS232.
 During input "ID 01-99" "@ID „must be placed in front of the remote control
command, so that the respective scale reacts to the instruction; e. g. to set the
scale to zero with ID 99 the instruction must be sent to "@99MZ" followed by the
control characters <CR><LF>.
 If there is an error on entered command, letter "E" will show up + "Unidentified
Command".
e.g. @99MZZ
The response message is  @99E1MZ.
 RS 485 responses only to machines of identified ID-Code.

13.5.1 Command Format A

Host Command
Slave
MZ Zeroing
MT Taring
MG Display gross weight
MN Indicate net weight
CT Delete tare
SC Continuous data output
SA Automatic data output
% Stop continuous data output and start instruction mode.
* depending on model

13.5.2 Command Format B

Host Command
Slave
RW Send current weight value
RG Send gross weight
RN Send net weight
RT Send tare weight
RB Send the display value without
status
KXS_KXG-TM-BA_IA-e-1932
Command
SO
Command mode
UA* Switch to the first unit*
UB* Switch to the second unit*
UC* Switch to the third unit *
UD* Switch to the forth unit *
UE* Switch to the fifth unit *
UF* Switch to the sixth unit *
Data
RH Send gross weight without status
RI Send net weight without status
RJ Hi /Lo/ OK status + display value
without status
RK Hi/Lo/ OK status + gross weight
without status
RL Rear one/ Lo/ OK status + net
weight without status
55